Ejector Pin Extensions - CMH Manufacturing

Extensions for ejector pins are recommended for applications where rigidity is considered very important or when standard stock ejector pins are not available in the required length.

Each extension is accurately machined from cold finished steel bars and furnished with two semi-finished hex nuts and two semi-finished hex jam nuts.

Please refer to the Typical Permanent Mold Assembly sheet and individual catalogue sheets for all your permanent mold component requirements.

Part Number	A	B	C	D	Ejector Pins Used With
99028	0.5000	6	10 - 32 x 3/4	1/2 - 20 x 3 1/2	0.1875
99029	0.5000	8	10 - 32 x 3/4	1/2 - 20 x 3 1/2	0.1875
99030	0.5000	12	10 - 32 x 3/4	1/2 - 20 x 3 1/2	0.1875
99033	0.5000	6	1/4 - 28 x 1	1/2 - 20 x 3 1/2	0.2460
99034	0.5000	8	1/4 - 28 x 1	1/2 - 20 x 3 1/2	0.2460
99035	0.5000	12	1/4 - 28 x 1	1/2 - 20 x 3 1/2	0.2460
99023	0.5000	6	5/16 - 24 x 1	1/2 - 20 x 3 1/2	0.3125
99024	0.5000	8	5/16 - 24 x 1	1/2 - 20 x 3 1/2	0.3125
99025	0.5000	12	5/16 - 24 x 1	1/2 - 20 x 3 1/2	0.3125
99038	0.5000	6	3/8 - 24 x 1	1/2 - 20 x 3 1/2	0.3750
99039	0.5000	8	3/8 - 24 x 1	1/2 - 20 x 3 1/2	0.3750
99040	0.5000	12	3/8 - 24 x 1	1/2 - 20 x 3 1/2	0.3750

Extensions for Ejector Pins